Description
PM2300E-100S
Line Interactive Long Run Time UPS
The PM200E Range is manufactured using a line Interactive design principal, and operates using a 220/240V 50Hz single phase input.
The UPS is designed to interact with the mains to supply a steady flow of power to
computer equipment. A high powered filter is incorporated into the machine to protect
against spikes and surges, as well as an automatic voltage regulator (AVR) to correct high or
low voltage fluctuations on the input. The use of an AVR will help to increase the battery life
of the UPS as it will be able to switch to battery power at a much lower (or higher) input
voltage. The input is monitored and as soon as the mains drops below a pre-set level or fails
completely the unit switches to battery inverted power. Switching time is well within the
tolerance of modern computer power supplies, and the output is a pure sine wave
matching the mains. The units are designed to run with external battery packs to allow for
enough backup power to keep the load running for up to 8 hours.
| Features | Benefits |
| Spike and Surge Protection | Built in filters to protect computers against harmful spikes and surges |
| Automatic Voltage Regulator | Built in two step AVR will reduce high input voltages and increase low level input voltages to
protect connected computer equipment from damage. |
| Sine Wave Output | The inverter produces a pure sine wave output similar to normal mains so can be used to power
any equipment. |
| Generator Compatible Input | All units are compatible with a generator providing the generator frequency is within 5 Hz. |
| DC Start Capability | Units are able to start and run with no mains input. Essentially the units can be run as a
straightforward inverter if necessary. |
| Communication Ports | 1KVA and 2KVA units are fitted with a USB communication port. This can be connected to the
USB port of a computer, and in conjunction with various software packages can supply information on the status of the UPS and perform an unattended shut down of the computer. |
| Model No. | PM2300E-100S |
| Capacity VA (Watts) | 3000 (2400) |
| Input Voltage | 230V AC + 25% |
| Input Frequency | 50 Hz + 10% |
| Transfer Time | Typical 2 to 7ms, maximum 10ms |
| Output Voltage On Inverter | 230V AC + 3% |
| Frequency on Inverter | 50 Hz Crystal Controlled |
| Inverter Wave Form | Sine Wave |
| Total Harmonic Distortion (THD) | < 3% |
| Efficiency At Full Load | > 90% |
| Overload Capability | 150% For 30 seconds, then by-pass |
| Model No. | PM2300E-100S | ||
| Ambient Operation | 3000M Max Elevation, 0 to 40 C, 20 to 90% Humidity | ||
| Audible Noise At 1 M | < 45 dbA | ||
| Short Circuit Protection | Yes | ||
| Low Battery Shutdown | Yes | ||
| Controls | Mains Fail Alarm (Slow intermittent beep), Low Battery Alarm (Continuous
beep), Mains on indicator, Charging indicator, Diagnostic software via USB port (PM2120 and PM2200 only) |
||
| UPS Dimensions (w x d x h) mm & Weight | 190 x 467 x 336 @ 28 Kgs | ||
| Battery Pack | 2 x 12V100Ah Fully Sealed Gel Batteries (12 year / 500 cycle design) | ||
| Run Time | 25% Load (600W) | 50% Load (1200W) | 75% Load (1800W) |
| 1.5 Hours | 2.25 Hours | 5 Hours | |
| Dimensions (W x L x H) | 500mm x 380mm x 320mm @ 65Kg | ||
