Description
J9775A
Aruba 2530 48G Switch
- Cost-effective, reliable and secure Aruba Layer 2 switch series
- Flexible Management via Aruba AirWave, Aruba Central, and Aruba ClearPass Policy Manager
- Right size deployment with choice of 8, 24 and 48 port Gigabit and Fast Ethernet models
- Up to 370W PoE+ to power IoT, APs and cameras
- REST API support
- Simple deployment with Zero Touch Provisioning
I/O ports and slots | 48 RJ-45 autosensing 10/100/1000 ports (IEEE 802.3 Type 10BASE-T, IEEE 802.3u Type 100BASE-TX, IEEE 802.3ab Type 1000BASE-T); Duplex: 10BASE-T/100BASE-TX: half or full; 1000BASE-T: full only | |
4 fixed Gigabit Ethernet SFP ports | ||
Additional ports and slots | 1 dual-personality (RJ-45 or USB micro-B) serial console port | |
Physical characteristics | Dimensions | 17.44(w) x 10.00(d) x 1.75(h) in (44.3 x 25.4 x 4.45 cm) (1U height) |
Weight | 6.8 lb (3.08 kg) | |
Memory and processor | Processor | ARM9E @ 800 MHz, 128 MB flash; Packet buffer size: 3 MB dynamically allocated, 256 MB DDR3 DIMM |
Mounting and enclosure | Mounts in an EIA-standard 19-inch telco rack or equipment cabinet (rack-mounting kit available); Horizontal surface mounting; Wall mounting | |
Performance | IPv6 Ready Certified | |
100 Mb Latency | < 7.4 µs (LIFO 64-byte packets) | |
1000 Mb Latency | < 2.3 µs (LIFO 64-byte packets) | |
Throughput | up to 77.3 Mpps (64-byte packets) | |
Switching capacity | 104 Gbps | |
MAC address table size | 16000 entries | |
Environment | Operating temperature | 32°F to 113°F (0°C to 45°C) |
Operating relative humidity | 15% to 95% @ 104°F (40°C), noncondensing | |
Non-operating/ Storage temperature |
-40°F to 158°F (-40°C to 70°C) | |
Non-operating/Storage relative humidity | 15% to 90% @ 149°F (65°C), noncondensing | |
Altitude | up to 10,000 ft (3 km) | |
Acoustic | Power: 34.5 dB, Pressure: 31.0 dB | |
Electrical characteristics | Frequency | 50/60 Hz Achieved Miercom Certified Green Award |
Maximum heat dissipation | 203 BTU/hr (214.17 kJ/hr) | |
Voltage | 100 – 127 / 200 – 240 VAC, rated | |
Current | 1.2/0.7 A | |
Maximum power rating | 59.5 W | |
Idle power | 29.5 W | |
Notes: | ÂÂ Idle power is the actual power consumption of the device with no ports connected.
ÂÂ Maximum power rating and maximum heat dissipation are the worst-case theoretical maximum numbers provided for planning the infrastructure with fully loaded PoE (if equipped), 100% traffic, all ports plugged in, and all modules populated. |
|
Safety | UL 60950-1; CAN/CSA 22.2 No. 60950-1; EN 60825; IEC 60950-1; EN 60950-1 | |
Emissions | FCC Class A; EN 55022/CISPR-22 Class A; VCCI Class A | |
Immunity | Generic | EN 55024, CISPR 24 |
EN | EN 55024, CISPR 24 | |
ESD | IEC 61000-4-2 | |
Radiated | IEC 61000-4-3 | |
EFT/Burst | IEC 61000-4-4 | |
Surge | IEC 61000-4-5 | |
Immunity | Conducted | IEC 61000-4-6 |
Power frequency magnetic field | IEC 61000-4-8 | |
Voltage dips and interruptions | IEC 61000-4-11 | |
Harmonics | EN 61000-3-2, IEC 61000-3-2 | |
Flicker | EN 61000-3-3, IEC 61000-3-3 | |
Management | IMC – Intelligent Management Center; command-line interface; Web browser; configuration menu; out-of-band management (serial RS-232C or Micro USB);IEEE 802.3 Ethernet MIB; Repeater MIB; Ethernet Interface MIB | |
Notes: | IEEE 802.3az applies to Gigabit models only; IEEE 802.3at and IEEE 802.3af apply to PoE+ models only. When using SFPs with this product, SFPs with revision “B” or later (product number ends with the letter “B” or later, e.g., J4858B, J4859C) are required. | |
Services | Refer to the Hewlett Packard Enterprise website at http://www.hpe.com/networking/services for details on the service-level descriptions and product numbers. For details about services and response times in your area, please contact your local Hewlett Packard Enterprise sales office. |